TO REPLACE BATTERIES:
In Robot Mode, pull back arm as shown. Use a Phillips/cross head screwdriver (not included) to
loosen screw in battery compartment door (screw remains attached to door). Remove door and
discard old batteries. Insert 2 x 1.5V fresh “AA” or R6 size batteries. Alkaline batteries recommended.
Replace door and tighten screw.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and –
polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-
zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other
types of batteries. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Reverse order of instructions
to convert back into robot.
17 18 19 20
button
NEED HELP?
TRANSFORMERS.COM/INSTRUCTIONS
Camaro and all related Emblems
and vehicle body designs are
General Motors Trademarks used
under license to Hasbro, Inc.
Retain instructions for
future reference.
P/N 7075990000
© 2010 DreamWorks LLC and Paramount Pictures Corporation
®* and/or TM* & © 2010 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
Manufactured under license from Tomy Company, Ltd.
Some poses may require hand support.
Arm converts to
plasma cannon!
Flip down mask! Push buttons for lights and sounds!
*
Push buttons for
lights and sounds!
Push button for
lights and sounds!
Press down front end for lights and sounds!
If sounds do not activate - see step 12 to ensure front
wheels
are fully snapped in.
button
ATTACK MODE
VEHICLE MODE
VEHICLE MODE
button
6
66
Csatlakozzon a termékről folytatott párbeszédhez
Itt megoszthatja véleményét a Hasbro 21305 Transformers Battle Ops Bumblebee-ról. Ha kérdése van, először figyelmesen olvassa el a kézikönyvet. Kézikönyv igénylése kapcsolatfelvételi űrlapunk segítségével történhet.