Használati útmutató Dyras CH-7515 Hősugárzó

Használati útmutató

CH-7515

8

EN

CH-7515

9

USING OF APPLIANCE

Before use

• Unpack the appliance and remove all the packing materials.

• Inspect the appliance and the accessories carefully to verify their soundness and undamaged condition. Only

perfectly sound and damage-free appliances may be connected to the electrical mains.

• Never leave the nylon packing bag, which is part of the package, within the reach of children who could play

with it.

• After checking that the heater is fit for operation, place it on a horizontal, stable surface where you wish to

use it. Don’t forget to place a heat resistant plate under the product before applying power, and take care

that no inflammable material is near to the device’s air outlet and inlet openings, and there is no object,

furniture or wall surface within the proscribed safety distance. Please always observe the stipulations of the

section “Important safety information” when positioning the device to avoid causing fire and accident risks.

• After setting up the appliance in a safe place, plug the mains cable into the wall socket (or an appropriate

extension socket).

Choosing the individual modes of operation

The device can be used without its heating function as a ventilator for moving air. To do this, move the operation

mode changing switch from “0” into “ ” position, then turn the temperature setting dial clockwise towards its

end position until the ventilator starts rotating. The device’s ON status is shown by the red operation indicator

light.

• If you wish to use the device for heating then please set the operation mode changing switch to its “I” or “II”

position, then turn the temperature setting dial clockwise towards its end position, as required.

• With the operating mode changing switch in position “I” the device’s heat output is 750 W; in position “II” its

heat output is 1500 W.

• To switch off the device, turn the operating mode changing switch to the “0” position, then withdraw the

mains connector from the wall socket or extension. Never disconnect the device in this way during operation.

Use of the room thermostat

• The premise’s room temperature can be continuously controlled using the temperature setting dial.

• Switch the device into heating operation mode, with the selection switch in ‘I’ or “II” position.

• Turn the temperature setting dial clockwise from its minimum position to its maximum position. The device

will then switch on and begin heating the room.

• When the room temperature has reached its desired level, turn back the temperature setting dial for your

optimum level of comfort. The device will then temporarily switch off, although some of its structural parts

willl remain connected to the live voltage supply.

• Make sure the heater is not likely to fall or to be knocked over when switched on because this could cause a

fire.

• The device can only be operated as a floor-standing unit; it must not be mounted on walls or ceilings. Using

the device in vehicles is not permitted.

• Keep the mains cable away from sharp or hot objects. Keep the cable away from the protective grill and the

hot air at the front of the heater. Never use the mains cable to pull or lift the heater.

• Warning! This heater is not designed for wet conditions. Never use the heater in a bathroom or in a kitchen.

Never use it near a basin, in a place that becomes wet or in an area with high relative humidity.

• The protective cover heats up during use; take care not to touch it.

• Before moving the heater, unplug it from the mains and wait until it has cooled down completely.

• Should the device capsize during use for any reason, the anti-capsize switch at the bottom of the cover will

automatically switch it off, thus preventing the risk of fire. It should be ensured during positioning of the

device that the switch is free to close, because the device can only be operated this way.

Please keep this instruction manual. If you give the appliance to anyone else, you must give them

this instruction manual, too!

MAIN COMPONENTS

1. Rear protection grid

2. Front protection grid

3. Operating mode change switch (0 \ \ I \ II)

4. Temperature setting dial/ room thermostat

5. Operation light

6. Mains cable and connector (not visible on the illustration)

POWER SUPPLY

The device can only be connected to a mains supply of 220-240 V~, 50 Hz. Always ensure that the

mains voltage at the point of use is between these lower and upper limit values.

User'sManual for CH-7515.indd 8-9User'sManual for CH-7515.indd 8-9 2011.06.29. 18:30:332011.06.29. 18:30:33

Értékelés

További információ erről a kézikönyvről

Megértjük, hogy jó, ha van egy papíralapú kézikönyv a Dyras CH-7515 Hősugárzó-hoz. A kézikönyvet bármikor letöltheti weboldalunkról, és saját maga is kinyomtathatja. Ha szeretne egy eredeti kézikönyvet, javasoljuk, hogy lépjen kapcsolatba a következővel: Dyras. Esetleg tudnak adni egy eredeti kézikönyvet. Más nyelvű kézikönyvet keres Dyras CH-7515 Hősugárzó készülékéhez? Válassza ki a kívánt nyelvet a honlapunkon, és keresse meg a modellszámot, hátha elérhető.

Műszaki adatok

Dyras Hősugárzók összes kézikönyve
Hősugárzók további kézikönyvei

Gyakran Ismételt Kérdések a következővel kapcsolatban: Dyras CH-7515 Hősugárzó

Ügyfélszolgálati csapatunk keresi a hasznos termékinformációkat, és válaszol a gyakran ismételt kérdésekre. Amennyiben pontatlanságot talál a gyakran ismételt kérdésekben, a kapcsolatfelvételi űrlapon jelezze nekünk a hibát.

Kapcsolódó termékek

Használati útmutató

Dyras DCH-1500 Hősugárzó

Használati útmutató

Dyras WHT-210 Hősugárzó

Használati útmutató

Dyras DCH-2000L Hősugárzó

Használati útmutató

Dyras HT-2000 Hősugárzó

Használati útmutató

Dyras HGH-8002 Hősugárzó

Használati útmutató

Dyras SFH-200 Hősugárzó

Használati útmutató

Tesla PC250WH Hősugárzó

Használati útmutató

Teesa TSA8054B Hősugárzó

Kapcsolódó kategóriák